Indoor Condensing Unit, 7-28kW

Liebert MCD, Indoor Condensing Unit, 7-28kWLiebert MCD condensing units are designed to be used in conjunction with the Liebert Mini-Mate2, Liebert DataMate and Liebert Challenger 3000 evaporator units, supporting effective data center cooling.

Liebert MCD Condensers are available in nominal capacities of 7kW to 28kW (2 to 8 tons). Air-cooled or water/glycol-cooled split system condensing units are mounted in the ceiling and connected to the evaporator unit by two refrigerant lines (four for 28kW (8-ton) model) and a low voltage control cable. The condensing unit, available in 50Hz or 60Hz, can be wired to a separate power source, or use the evaporator power source when close-coupled together.



  • Indoor air and water/glycol condensing unit
  • Supports smaller Liebert precision cooling systems
  • Installs easily
  • Operates quietly




  • Offers models for air-cooled or water/glycol-cooled heat rejection sources.
  • Close-couples with evaporator unit to allow a single electrical power source to be used for both units.

Higher Availability

  • Operates with quiet, high efficiency scroll compressor with internal vibration isolation mountings, pressure safety controls and built-in overload protection.
  • Features standard scroll compressor, hot gas bypass, crankcase heater, high pressure switch, condenser coil, sight glass, and filter/dryer.

Lowest Total Cost Of Ownership

  • Delivers to the site fully wired, piped and tested.
  • Runs efficiently at partial load conditions and reduces compressor start/stop cycles and resultant wear by using hot gas bypass feature.
  • Allows faster and efficient plan approval and building inspection with CSA agency approval.

Ideally Suited For

  • Data centers
  • Telecommunications facilities
  • Industrial process control centers
  • Laboratories
  • Other sensitive electronic applications